Nissan Pulsar/Nissan
Sunny GTIR Engine Specifications with Acceleration and 1/4mile times.
Based on an article which originally appeared in Banzai Magazine
No.5-2005. The acceleration tests were carried out at Bruntingthorpe
using Race Technologies AX22 timing equipment.
Specs:
SR20DET, Tomei
270Deg cams with 12.5mm lift, Tomei pulleys and valve springs,
Turbonetics turbo, R33 intercooler, tubular manifold, Apexi Power FC Pro
ECU, Blitz DSBC boost controller, 700cc injectors, Front mounted
intercooler, non vented bonnet, battery re located to boot. Yokohama
A080 Cut slick tyres.
Specs:
SR20DET, Norris Designs rebuild with 2.5mm oversized forged pistons and
rings, lightened and balanced crankshaft and con rods, Norris Designs
ported and polished cylinder head, HKS 2mm head gasket, Garrett hybrid turbo,
match ported manifold and inlet, forged pulleys, Pace RS500 front
mounted intercooler with custom water spray, HKS 264Deg cams, Sard 700cc
injectors, Z32 AFM, Mocal 19 row top mounted oil cooler, Profec B boost
controller, Apexi Power FC ECU with Omex launch control and full
throttle gearshift, ERL water injection with 20%methanol, Norris Designs
adjustable FPR, Norris Designs Group A fuel pump, 75mm dump pipe and
down pipe, NOS 40bhp wet nitrous fogger kit, Turbosmart dump valve, K&N
induction kit, heat wrapped and shortened induction line, Mongoose
stainless steel exhaust system, The Phirm breather system, battery
relocated to boot, Quaife close ratio straight cut dog box with shot
peened selector forks, Exedy Hyper single plate triple paddle clutch,
Jun titanium lightweight flywheel, B&M short shifter mechanism, Nismo
engine mounts.
Performance Times:
No figures recorded due to broken distributor shaft.
Sunny/Pulsar GTi-R 5.
Specs:
SR20DET rebuilt by HiTeq, lightened and valanced knife edge crankshaft,
HKS pistons, HKS
264Deg cams, HKS head gasket, 600cc injectors, Z32 AFM, Apexi Power FC
ECU mapped for 1.4 bar
boost, ND stage two front mounted intercooler, ND super hybrid turbo,
GReddy boost controller, HiTeq hard pipe kit, Blitz air filter, HKS
front pipe, de cat pipe, Trust exhaust system
with 4.5" tail pipe, Helix organic clutch.
Specs:
SR20DERT, balanced bottom end, ARP bolts, Trust pistons,
Tuning Japanese stage 3 high lift
cams, vernier cam gears, steel head gasket, 720cc injectors, Walbro fuel
pump, Sard adjustable FPR,
NGK spark plugs, Magnecor racing plug leads, MSD SS Blaster coil, MoTeC
M48 ECU with 3 bar map
sensor and air temp sensor, HKS air filter, Blitz blow off valve,
Garrett T2871R turbo with 4" inlet pipe, SS Auto Chrome S14 twin dump
pipe, custom 4" alloy inlet pipe with Pipercross filter in cold air box,
SS Autochrome S14 tubular manifold, Mongoose stainless steel exhaust
system with de cat and modified down pipe, GTIR Spares front mounted
intercooler, Mocal 16 row oil cooler, Nismo engine and gearbox mounts,
custom alloy tanks and engine covers, Quaife syncromesh gearbox,
quickshift mechanism, AP Racing paddle clutch.
Specs:SR20DET, fully balanced bottom end, TK forged pistons and steel
con rods, Tuning Japanese
1.2mm metal head gasket, Tuning Japanese competition bearings, Tuning
Japanese head bolt kit, Tuning Japanese oil cooler kit, TJ gas flowed
and ported cylinder head, TJ camshafts, Trust T67 turbo with stainless
steel tubular manifold and Type R wastegate, HKS EVC V boost controller,
Denso 720cc injectors, custom TJ/GT-R front mounted intercooler with
mandrel bent hard pipes, TJ 280L/P/H fuel pump, Nismo regulator,
relocated battery, custom TJ intake pipe kit, MoTeC M48 Pro ECU, TJ
front pipe leading to Mongoose stainless steel exhaust system, TJ shot
peened GTi-R transmission with modified syncromesh and baulk rings, AP
Racing single plate clutch.